Alcatel-Lucent 7750 SR OS - Page 380

Configuration Commands
Page 380 7750 SR OS Interface Configuration Guide
SONET/SDH Path Commands
path
Syntax [no] path [sonet-sdh-index]
Context config>port>sonet-sdh
Description This command defines the SONET/SDH path.
The no form of this command removes the specified SONET/SDH path.
Default full channel (or clear channel)
Parameters sonet-sdh-index — Specifies the components making up the specified SONET/SDH path. Depending
on the type of SONET/SDH port the sonet-sdh-index must specify more path indexes to specify
the payload location of the path. The sonet-sdh-index differs for SONET and SDH ports.
Syntax: sts1-x.x
In addition the support of virtual tributary circuits adds an additional level of complexity and several
addition levels of indexes.
payload
Syntax payload {sts3 | tug3 | ds3 | e3}
Context config>port>sonet-sdh>path
Description This command specifies if the associated SONET/SDH path is an asynchronous circuit or a virtual
tributary group (VT). This command is only applicable to channelized MDAs.
SONET SDH
OC-192 STS-48-index
STS-12-index
STS-3-index
STS-1-index
STM-64 AUG-16-index
AUG-4-index
AUG-1-index
AU-3-index
OC-48 STS-12-index
STS-3-index
STS-1-index
STM-16 AUG-4-index
AUG-1-index
AU-3-index
OC-12 STS-3-index
STS-1-index
STM-4 AUG-1-index
AU-3-index
OC-3 STS-1-index STM-1 AU-3-index