Alcatel-Lucent 7750 SR OS - Page 388

Configuration Commands
Page 388 7750 SR OS Interface Configuration Guide
min-vp-vpi
Syntax min-vp-vpi value
Context config>port>sonet-sdh>path>atm
config>port>multilink-bundle>ima>atm
config>port>tdm>ds1>channel-group>atm
config>port>tdm>ds3>atm
config>port>tdm>e1>channel-group>atm
config>port>tdm>e3>atm
Description This command sets the minimum allowable virtual path identifier (VPI) value that can be used on the
ATM interface for a VPC.
Parameters value — Specify the minimum allowable VPI value that can be used on the ATM interface for a VPC.
Values 0 — 4095 (NNI)
0 — 255 (UNI)
Default 0
ilmi
Syntax ilmi [vpi/vci]
no ilmi
Context config>port>sonet-sdh>path>atm
Description This command creates an ILMI link PVCC by default on VPI/VCI 0/16. Deleting an ILMI link
deletes the PVCC. ILMI is supported only on ATM interfaces on SONET/SDH paths.
Parameters vpi/vci — Specifies the PVC identifier (vpi/vci).
Values vpi 0 — 4095 (NNI)
0 — 255 (UNI)
vci 1, 2, 5 — 65535
egress
Syntax egress
Context config>port>sonet-sdh>path>atm>ilmi
Description This command enables the context to configure egress traffic attributes for the ILMI link.