Alcatel-Lucent 7750 SR OS - Page 394

Configuration Commands
Page 394 7750 SR OS Interface Configuration Guide
Parameters dce — Enables the DCE mode.
dte — Enables the DTE mode.
bidir — Enables the bidirectional mode for LMI types ANSI and ITU.
n391dte
Syntax n391dte intervals
no n391dte
Context config>port>sonet-sdh>path>frame-relay
config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
Description This command sets the DTE full status polling interval for the Frame Relay Local Management
Interface (LMI). The number specifies the frequency at which inquiries expect a full status report.
The no form of this command returns the n391dte counter to the default value.
Default 6
Parameters intervals — The number of exchanges to be done before requesting a full-status report. A value of 1
specifies to receive full-status messages only.
Values 1 — 255
n392dce
Syntax n392dce threshold
no n392dce
Context config>port>sonet-sdh>path>frame-relay
config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
Description This command sets the DCE error threshold for the Frame Relay Local Management Interface (LMI).
The threshold specifies the number of errors needed to bring down a link.
The no form of this command returns the n392dce counter to the default value.
Default 3
Parameters threshold — Specify the number of errors that will place the channel in an operationally down state.
Values 1 — 10