Alcatel-Lucent 7750 SR OS - Page 413

Interface Configuration
7750 SR OS Interface Configuration Guide Page 413
port — Specifies the port ID code up to 38 characters long.
gen — Specifies the generator number to send in the MDL test signal message up to 38 characters
long.
mdl-transmit
Syntax mdl-transmit {path | idle-signal | test-signal}
no mdl-transmit [path | idle-signal | test-signal]
Context config>port>tdm>ds3
config>port>tdm>e3
Description This command enables the transmission of an MDL message on a DS-3/E-3 over channelized
interface.
The no form of this command disables transmission of the specified message or all messages.
Default no mdl-transmit
Parameters path — Specify the MDL path message.
idle-signal — Specify the MDL idle signal message.
test-signal — Specify the MDL test signal message.
remote-loop-respond
Syntax [no] remote-loop-respond
Context config>port>tdm>ds1
Description When abled, the channel responds to requests for remote loopbacks.
Default no remote-loop-respond — The port will not respond.
report-alarm
Syntax [no] report-alarm [ais] [los] [oof] [rai] [looped] [ber-sd] [ber-sf]
Context config>port>tdm>ds1
config>port>tdm>e1
Description This command enables logging of DS-1/DS-3 or E-1/E-3 alarms for DS-1/DS-3 or E-1/E-3 ports or
channels.
The no form of this command disables logging of the specified alarms.
Parameters ais — Reports alarm indication signal errors. When configured, ais alarms are not raised and cleared.
Default ais alarms are issued