Configuration Commands
Page 416 7750 SR OS Interface Configuration Guide
rate — Specifies the number of errors, in millions.
timeslots
Syntax timeslots timeslots
no timeslots
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command defines the list of DS-0 timeslots to be used in the DS-1 or E-1 channel-group. The
timeslots are defaulted as defined below when encap-type is set to/from atm. ATM channel groups do
not allow timeslots to change.
The no form of this command removes DS-0 timeslots from a channel group.
Default no timeslots — Non-ATM channel groups.1-24 — Channel groups configured under DS-1 with
encap set to ATM.
2-16,18-32 — Channel groups configured under E-1 with encap set to ATM.
Description timeslots — Specifies the timeslot(s) to be associated with the channel group. The value can consist
of a list of timeslots. Each member of the list can either be a single timeslot or a range of
timeslots.
Values 1 — 24 for DS-1 interfaces (the full range is auto-configured for ATM channel
groups and cannot be changed).
2 — 32 for E-1 interfaces (the 2 — 16,18 — 32 ranges are auto-configured for
ATM channel groups and cannot be changed).
To Next Page
Loading...
