Alcatel-Lucent 7750 SR OS - Page 418

Configuration Commands
Page 418 7750 SR OS Interface Configuration Guide
access
Syntax access
Context config>lag
Description This command enables the context to configure access parameters.
adapt-qos
Syntax adapt-qos type
Context config>lag>access
Description This command specifies how the LAG SAP queue and virtual scheduler buffering and rate
parameters are adapted over multiple active MDAs. This command applies only to access LAGs.
Default distribute
Parameters type — Specify the QoS adaptation type.
Values link — Specifies that the LAG will create the SAP queues and virtual schedulers
with the actual parameters on each LAG member port.
distribute — Creates an additional internal virtual scheduler per IOM as parent of
the configured SAP queues and vitual schedulers per LAG member port on that
IOM. This internal virtual scheduler limits the total amount of egress bandwidth for
all member ports on the IOM to the bandwidth specified in the egress qos policy.
per-fp-ing-queuing
Syntax [no] per-fp-ing-queuing
Context config>lag
Description This command specifies whether a more efficient method of queue allocation for LAG SAPs should
be utilized.
The no form of the command disables the method of queue allocation for LAG SAPs.
dynamic-cost
Syntax [no] dynamic-cost
Context config>lag lag-id
Description This command enables OSPF/ISIS costing of a Link Aggregation Group (LAG) based on the
available aggregated, operational bandwidth.