Configuration Commands
Page 424 7750 SR OS Interface Configuration Guide
Eth Ring Commands
eth-ring
Syntax eth-ring ring-id
no eth-ring
Context config
Description This command configures a G.8032 protected Ethernet ring. G.8032 Rings may be configured as
major rings with two paths (a&b).
The no form of this command deletes the Ethernet ring specified by the ring-id.
Default no eth-ring
Parameters ring-id — Specifies the ring ID.
Values 1-512
description
Syntax description long-description-string
no description
Context config>eth-ring
Description This command adds a text description for the ring. The no form of this command removes the text
description.
Default “Eth ring”
Parameters string — Specifies the text description up to 160 characters in length.
guard-time
Syntax guard-time time
no guard-time
Context config>eth-ring
Description This command configures the guard time for an Eth-Ring. The guard timer is standard and is
configurable from x ms to 2 seconds
The no form of this command restores the default guard-time.
Default 5 deciseconds
To Next Page
Loading...
