Configuration Commands
Page 434 7750 SR OS Interface Configuration Guide
hold-time
Syntax hold-time
Context config>eth-tunnel
Description This command configures eth-tunnel dampening timers.
member
Syntax member down time
no member
Context config>eth-tunnel>hold-time
Description A default MAC address is assigned by the system from the chassis MAC address pool.This command
specifies the timer, which controls the delay between detecting that member path is down and
reporting it to the G.8031 protection module. If a non-zero value is configured, the CPM will wait for
the time specified in the value parameter before reporting it to the G.8031 protection module. Note
that this parameter applies only to member path CCM. It does NOT apply to the member port link
state. To damp member port link state transitions, use hold-time parameter from the physical member
port.
The no form of this command sets the hold-time to the default value.
Default no member - the fault will be reported immediately to the protection module.
Parameters value — Specifies the hold-time for reporting the failure.
Values 1-1000 centiseconds
lag-emulation
Syntax lag-emulation
Context config>eth-tunnel
Description This command configures eth-tunnel loadsharing parameters.
access
Syntax access
Context config>eth-tunnel>lag-emulation
Description This command configures eth-tunnel loadsharing access parameters
To Next Page
Loading...
