Configuration Commands
Page 436 7750 SR OS Interface Configuration Guide
protection-type
Syntax protection-type {g8031-1to1 | loadsharing}
Context config>eth-tunnel
Description This command configures the model used for determining which members are actively receiving and
transmitting data.
The no form of the command reverts the default.
Default no path-threshold
Parameters g8031-1to1 — As per G.8031 spec, only two members are allowed, and only one of them can be
active at one point in time.
loadsharing — Multiple members can be active at one point in time.
revert-time
Syntax revert-time time
no revert-time
Context config>eth-tunnel
Description This command configure how long to wait before switching back to the primary path after it has been
restored to Ethernet tunnel.
The no form of this command sets the revert-time to the default value.
Default no revert-time – indicates non-revertive behavior.
Parameters time — Specifies the re-activation delay in seconds for the primary path.
Values 1 — 720 seconds
path
Syntax [no] path path-index
Context config>eth-tunnel
Description This command configures one of the two paths supported under the Ethernet tunnel. Although the
values indicate 1 — 8, only two paths, 1 and 2, are currently supported.
The no form of this command removes the path from under the Ethernet tunnel. If this is the last path,
the associated SAP need to be un-configured before the path can be deleted.
Default no path
Parameters path-index — Specifies the identifier for the path.
Values 1 — 8
To Next Page
Loading...
