Interface Configuration
7750 SR OS Interface Configuration Guide Page 449
passive-mode
Syntax [no] passive-mode
Context config>redundancy>multi-chassis>peer>mc-ep
Description This command configures the passive mode behavior for the MC-EP protocol. When in passive mode
the MC-EP pair will be dormant until two of the pseudowires in a MC-EP will be signaled as active
by the remote PEs, being assumed that the remote pair is configured with regular MC-EP. As soon as
more than one pseudowire is active, dormant MC-EP pair will activate. It will use the regular
exchange to select the best pseudowire between the active ones and it will block the Rx and Tx
directions of the other pseudowires.
The no form of this command will disable the passive mode behavior.
Default
no passive-mode
system-priority
Syntax system-priority value
no system-priority
Context config>redundancy>multi-chassis>peer>mc-ep
Description This command allows the operator to set the system priority. The peer configured with the highest
value is chosen to be the Master. If system-priority are equal then the one with the lowest system-id
(chassis MAC address) is chosen as the Master.
The no form of this command sets the system priority to default
Default 0
Parameters value — Specifies the priority assigned to the local MC-EP peer.
Values 1— 255
To Next Page
Loading...
