Forwarding Plane Commands
Page 466 7750 SR OS Interface Configuration Guide
Description This CLI node contains the forwarding plane or MDA settings for ingress multicast path
management. Enter the node to configure the bandwidth-policy, the individual path bandwidth
overrides and the administrative state of ingress multicast path management.
bandwidth-policy
Syntax bandwidth-policy policy-name
no bandwidth-policy
Context config>card>fp>ingress>mcast-path-management
config>card>mda>ingress>mcast-path-management
Description This command is used to explicitly associate a bandwidth policy to a forwarding plane or MDA. The
bandwidth policy defines the dynamic rate table and the multicast paths bandwidth and queuing
parameters.
If a bandwidth policy is not explicitly associated with a forwarding plane or MDA, the default
bandwidth policy is used when ingress multicast path management is enabled.
The no form of the command removes an explicit bandwidth policy from a forwarding plane or MDA
and restores the default bandwidth policy.
Parameters policy-name — The policy-name parameter is required and defines the bandwidth policy that should
be associated with the MDA or forwarding plane for ingress multicast path management. If the
policy name does not exist, the bandwidth-policy command will fail.
Values Any existing bandwidth policy name
Default default
primary-override
Syntax primary-override
Context config>card>mda>ingress>mcast-mgmt
Description This command enables the context to configure MDA ingress multicast path-limit overrides.
The path override CLI nodes are not supported on IOM-3.
secondary-override
Syntax secondary-override
Context config>card>mda>ingress>mcast-mgmt
Description This command enables the context to configure MDA ingress multicast path-limit overrides.
The path override CLI nodes are not supported on IOM-3.
To Next Page
Loading...
