Alcatel-Lucent 7750 SR OS - Page 484

Show Commands
Page 484 7750 SR OS Interface Configuration Guide
Context show
Description This command displays Ethernet Link Management Interface (eLMI) information.
ELMI Output — The following table describes eLMI output fields.
evc
Syntax evc [port-id [vlan vlan-id]]
Context show>elmi
Description This command displays Ethernet Virtual Connections (EVC). No argument displays all the EVC on
the service router. The port and VLAN arguments display information related to EVC associated
with the port and VLAN.
Parameters port-id — Displays information related to the EVCs configured on the port
Values slot/mda/port
Field Description
Link Status Status of the E-LMI protocol when the elmi mode is set to uni-n. Link
Status will indicate up if eLMI mode is set to "none".
T391 pooling timer used by UNI-C. UNI-N will send the consecutive single
EVC asynchronous status messages every (T391/10) rounded to the
second interval.
T392 Pooling verification timer for UNI-N
N393 Status counter for UNI-N
Rx Enq. Time Last time when a status enquiry message was received from UNI-C.
Rx Enq Msg Number of status enquiry messages received.
Rx Check Time Last time when a status enquiry E-LMI check message was received.
Rx Inv. SeqNum Counts the number of E-LMI messages received with invalid
sequence number.
Enq Timeouts Counts the number of T392 timer expired.
Tx Status Time Last time when a status message was sent by UNI-N.
Tx Status Msg Number of status messages sent by UNI-N.
Tx Check Time Last time when a status eLMI check message was sent by UNI-N.
Tx Async Status
Msg
Counter for single EVC asynchronous status messages sent by UNI-N.
Discard Msg Counter for the status enquiry messages discarded due to errors.