Alcatel-Lucent 7750 SR OS - Page 502

Show Commands
Page 502 7750 SR OS Interface Configuration Guide
Sample Output
show aps on a working multi-chassis APS node:
*A:Dut-A# show aps aps-1
===============================================================================
APS Group Info
===============================================================================
Interface Admin Oper MC-Ctl Work Prot Active Tx/Rx
State State State Circuit Circuit Circuit K1 Byte
-------------------------------------------------------------------------------
aps-1 Up Up N/A 1/5/1 1/9/5 1/5/1 PC-Tx: No-Req
===============================================================================
*A:Dut-A#
*A:Dut-A# show aps aps-1 detail
===============================================================================
APS Group: aps-1
===============================================================================
Description : APS Group
Group Id : 1 Active Circuit : 1/5/1
Admin Status : Up Oper Status : Up
Working Circuit : 1/5/1 Protection Circuit : 1/9/5
Switching-mode : Uni-1plus1 Switching-arch : 1+1(sig,data)
Revertive-mode : Non-revertive Revert-time (min) :
Rx K1/K2 byte : 0x00/0x00 (No-Req on Protect)
Tx K1/K2 byte : 0x00/0x00 (No-Req on Protect)
Current APS Status : OK
Multi-Chassis APS : No
Neighbor : 0.0.0.0
Control link state : N/A
Advertise Interval : 1000 msec Hold Time : 3000 msec
APS SF Hold Time : 6000 msec APS SD Hold Time : 9000 msec
Mode mismatch Cnt : 0 Channel mismatch Cnt : 0
PSB failure Cnt : 0 FEPL failure Cnt : 0
-------------------------------------------------------------------------------
APS Working Circuit - 1/5/1
-------------------------------------------------------------------------------
Admin Status : Up Oper Status : Up
Signal Failure
Cnt
Displays the number of times the signal failed.
Last Switch Cmd
Reports the last switch command that was performed on a circuit.
Last Exercise
Result
The result of the last exercise request on a circuit.
Neighbor address
Displays the neighbor IP address.
Advertise Inter-
val
Displays the advertise interval.
Hold time
Displays the hold time.
Label Description (Continued)