Show Commands
Page 508 7750 SR OS Interface Configuration Guide
Sample Output
*A:ALU-211# show port 1/1/2
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100 Ethernet TX
Link Up — A port that is physically present and has physical link
present.
Note that when Link Up appears at the lowest level of a SONET/SDH
path or a TDM tributary, it means the physical connection is active but
the port is waiting on some other state before data traffic can flow. It is
a waiting state and indicates that data traffic will not flow until it tran-
sitions to the Up state.
Link Down — A port that is physically present but does not have a
link.
Cfg MTU
The configured MTU.
Oper MTU
The negotiated size of the largest packet which can be sent on the port
SONET/SDH, channel, specified in octets.
For channels that are used for transmitting network datagrams, this is
the size of the largest network datagram that can be sent on the chan-
nel.
LAG ID
The LAG or multi-link trunk (MLT) that the port is assigned to.
Port Mode
network — The port is configured for transport network use.
access — The port is configured for service access.
Port Encap
Null — Ingress frames will not use tags or labels to delineate a ser-
vice.
dot1q — Ingress frames carry 802.1Q tags where each tag signifies
a different service.
Port Type
The type of port or optics installed.
SFP/MDI MDX
GIGE — Indicates the GigE SFP type.
FASTE — Indicates the FastE SFP type.
GIGX — Indicates the GigX SFP type.
MDI — Indicates that the Ethernet interface is of type MDI (Media
Dependent Interface).
MDX — Indicates that the Ethernet interface is of type MDX (Media
Dependent Interface with crossovers).
Label Description (Continued)
To Next Page
Loading...
