Alcatel-Lucent 7750 SR OS - Page 545

Interface Configuration
7750 SR OS Interface Configuration Guide Page 545
Output Port ATM PVC VP/VCI Output — The following table describes port ATM PVC VPI/VCI output
fields.
port (atm pvc vpi/vci) Sample Output
ALA-1# show port 9/1/2 atm pvc
================================================================
ATM Endpoints, Port 9/1/2
================================================================
VPI/VCI Owner Type Ing.TD Egr.TD Adm OAM Opr
----------------------------------------------------------------
0/500 SAP PVC 5 3 up ETE-AIS dn
================================================================
ALA-1#
Label Description
Port Id
The port ID configured or displayed in the slot/mda/port format.
VPI/VCI
Displays the VPI/VCI values.
Admin State
Displays the administrative state of the interface connection.
Oper State
Indicates the status of the ATM interface.
OAM State
Indicates the OAM operational status of ATM connections.
ETE indicates end-to-end connection.
AIS denotes alarm indication signal.
RDI denotes for remote defect indication.
LOC indicates the alarm was due to loss of continuity.
Encap Type
Indicates the encapsulation type.
Owner
Identifies the system entity that owns a specific ATM connection.
Type
Indicates the connection type.
Ing. TD
Specifies the ATM traffic descriptor profile that applies to the receive
direction of the interface connection.
Egr. TD
Specifies the ATM traffic descriptor profile that applies to the transmit
direction of the interface connection.
ILMI Vpi/Vci
Range
On links that have ILMI enabled ok displays only if the VPI/VCI falls
within the ILMI links valid range for a connection.
If n/a displays, then ILMI is not available to check.
Adm
Displays the administrative state of the interface connection.
OAM
Indicates the OAM operational status of ATM connections.
ETE indicates end-to-end connection.
AIS denotes alarm indication signal.
RDI denotes for remote defect indication.
LOC indicates the alarm was due to loss of continuity.