Interface Configuration
7750 SR OS Interface Configuration Guide Page 547
ATM PVC Detail Output Fields
Output Port ATM PVC Detail Output — The following table describes port ATM PVC detail output
fields.
Label Description
Port Id
The port ID configured or displayed in the slot/mda/port format.
VPI/VCI
Displays the VPI/VCI values.
Admin State
Displays the administrative state of the interface connection.
Oper State
Indicates the status of the ATM interface.
OAM State
Indicates the OAM operational status of ATM connections.
ETE indicates end-to-end connection.
AIS denotes alarm indication signal.
RDI denotes for remote defect indication.
LOC indicates the alarm was due to loss of continuity.
Encap Type
Indicates the encapsulation type.
Owner
Identifies the system entity that owns a specific ATM connection.
AAL Type
Displays ATM Adaptation Layer 5 (AAL5) information.
Endpoint Type
Displays the endpoint type.
Cast Type
Indicates the connection topology type.
Type
Indicates the connection type.
Ing. Td Idx
Specifies the ATM traffic descriptor profile that applies to the receive
direction of the interface connection.
Egr. Td Idx
Specifies the ATM traffic descriptor profile that applies to the transmit
direction of the interface connection.
Last Changed
Indicates the date and time when the interface connection entered its
current operational state.
Octets
Displays the number of input and output octets.
HEC discarded cells are not included in the input octet numbers
Cells
Displays the number of input and output cells.
HEC discarded cells are not included in the input cell numbers
Packets
Displays the number of input and output packets.
Packets discarded due to HEC or oversize discards are not counted.
CRC errors are also in the packet counts show up on the VC level sta-
tistics but not on the port level.
Dropped Packets
Displays the number of packets dropped by the ATM SAR device.
To Next Page
Loading...
