Alcatel-Lucent 7750 SR OS - Page 590

Show Commands
Page 590 7750 SR OS Interface Configuration Guide
Sample Output
A:ALA-48>config# show lag
===============================================================================
Lag Data
===============================================================================
Lag-id Adm Opr Port-Threshold Up-Link-Count MC Act/Stdby
-------------------------------------------------------------------------------
1 up down 0 0 N/A
2 up up 0 1 active
3 up down 0 0 standby
4 up down 0 0 standby
10 up down 0 0 N/A
-------------------------------------------------------------------------------
Total Lag-ids: 5 Single Chassis: 2 MC Act: 1 MC Stdby: 2
===============================================================================
A:ALA-48>config# show lag
Detailed LAG Output — The following table describes detailed LAG output fields. The output is
dependent on whether or not the LAG was configurd as a multi-chassis LAG.
Detailed LAG Output Fields
Label Description
LAG ID
The LAG or multi-link trunk (MLT) that the port is assigned to.
Adm
Up — The LAG is administratively up.
Down — The LAG is administratively down.
Port Threshold
If the number of available links is equal or below this number, the
threshold action is executed.
Thres. Last
Cleared
The last time that keepalive stats were cleared.
Dynamic Cost
The OSPF costing of a link aggregation group based on the available
aggregated, operational bandwidth.
Configured
Address
The base chassis Ethernet MAC address.
Hardware Address
The hardware address.
Hold-Time Down
The timer, in tenths of seconds, which controls the delay between
detecting that a LAG is down and reporting it to the higher levels.
LACP
Enabled — LACP is enabled.
Down — LACP is disabled.
LACP Transmit
Intvl
LACP timeout signalled to peer.
Selection Crite-
ria
Configured subgroup selection criteria.
Number of sub-
groups
Total subgroups in LAG.