Alcatel-Lucent 7750 SR OS - Page 610

Tools Commands
Page 610 7750 SR OS Interface Configuration Guide
eth-tunnel
Syntax eth-tunnel tunnel-index [clear]
Context tools>dump
Description This command displays Ethernet tunnel information.
Sample Output
*A:PE-E# tools dump eth-tunnel 1
TunnelId 1 (Up/Up), Port eth-tunnel-1 (Up/Up): type g8031-1to1
NumMems 2/2, Up/Dn 0/0, active 0x1, present 0x3 baseMemPort 1/1/2
memId 1 (P), port 1/1/2 (Up), tag 1.0(Up) status (Up/Up)
ccCnt-sf/ok 1/1 idx 0 tunId 1
memId 2 (S), port 2/1/2 (Up), tag 1.0(Up) status (Up/Up)
ccCnt-sf/ok 0/0 idx 1 tunId 1
TunId = 1, state = Running, Active = Work, Now = 000 00:16:48.140
revert = 1, ReqState = NR-NULL, Pdu(Tx/Rx): 0x0f0000/0x0f0000
Defects =
Running Timers = PduReTx
Work MemId = 1 (1/1/2:1.0), state = Ok, cc = 000 00:16:23.510U
ActiveCnt = 4, ActiveSeconds = 791
Protect MemId = 2 (2/1/2:1.0), state = Ok, cc = 000 00:09:47.560U
ActiveCnt = 3, ActiveSeconds = 308
DbgCnts: swoEv = 2, wMemSts = 2, pMemSts = 0
rxPdu (valid/Invalid) = 4/0, wSfClr = 1, pSfClr = 0, wtrExp = 1
cm = 0, cmClr = 0, pm = 0, pmClr = 0, nr = 0, nrClr = 0
Seq Event TxPdu RxPdu Dir Act Time
=== ======== ============ ============ ===== ==== ================
000 wMemSts 0xbf0101 wSF 0x0f0000 NR Tx--> Prot 000 00:16:12.450
001 RxPdu 0xbf0101 wSF 0x0f0101 NR Rx<-- Prot 000 00:16:12.450
002 RxPdu 0xbf0101 wSF 0xbf0101 wSF Rx<-- Prot 000 00:16:12.480
003 RxPdu 0xbf0101 wSF 0x0f0101 NR Rx<-- Prot 000 00:16:24.890
004 wSFClr 0x5f0101 WTR 0x0f0101 NR Tx--> Prot 000 00:16:25.030
005 WTR 0x0f0000 NR 0x0f0101 NR Tx--> Work 000 00:16:26.630
006 RxPdu 0x0f0000 NR 0x0f0000 NR Rx<-- Work 000 00:16:26.630
*A:PE-E#
frame-relay
Syntax frame-relay port-id
Context This command displays frame-relay information.
Parameters port-id — Specifies the physical port ID.
Syntax: slot/mda/port[.channel]
Sample Output