Alcatel-Lucent 7750 SR OS - Page 616

Debug Commands
Page 616 7750 SR OS Interface Configuration Guide
Debug Commands
lmi (frame-relay)
Syntax lmi [port-id]
no lmi
Context debug>frame-relay
Description This debug command enables tracing of all the LMI messages in both receive and transmit directions
for one or all of the Frame Relay interfaces. All types of Frame Relay interfaces are supported. If the
port ID is not specified, debug is enabled on all Frame Relay interfaces.
The no form of the command turns off LMI and Frame-Relay debugging, debug>frame-relay>no
lmi and debug>no frame-relay.
Parameters port-id — Specifies the ILMI-supporting port ID.
Syntax: slot/mda/port[.channel]
Sample Output
2959 2007/04/11 23:01:34.63 MINOR: DEBUG #2001 - FR
"FR: TX STATUS Msg on dce Port: 1/1/1 LMI: itu
FR Hdr: 00 01 03 08 00 7D
Rpt IE: 51 01 01 LINK_INT_VERIFY
KA IE: 53 02 31 45 TxSeqNo=49 RxSeqNo=69"
2960 2007/04/11 23:01:44.63 MINOR: DEBUG #2001 - FR
"FR: RX STATUS ENQ Msg on dce Port: 1/1/1 LMI: itu
FR Hdr: 00 01 03 08 00 75
Rpt IE: 51 01 01 LINK_INT_VERIFY
KA IE: 53 02 46 31 TxSeqNo=70 RxSeqNo=49"
ilmi (atm)
Syntax [no] ilmi port-id
Context debug>atm
Description This command enables debugging for ATM ILMI.
The no form of the command turns off ILMI and debugging,.
Parameters port-id — Specifies the ILMI-supporting port ID.
Values slot/mda/port[.channel]