Alcatel-Lucent 8232 DECT Handset - 8.2 Registering the telephone on other systems

8232 DECT Handset
8AL90862USABed01
41 /55
Utilization of the telephone in GAP mode can lead to functional limitats for whichno claims will be
considered under the terms of the warranty.
8.2 Registering the telephone on other systems
The telephone can be registered on several systems (maximum of 4).
Note: the input is usually reserved for use with your main ALE International system. You can select the
other inputs to register the telephone under another system (ALE International or other system).
8.2.1 To make a new registration, when the telephone has already been registered on one
or more systems, proceed as follows:
1. Prepare your system for registration (see the system installation manual or consult your installation
manager).
2. When the system is ready:
 Access MENU.
 Install
 Register
 Enter the PIN Code.
 Apply.
 Select a system.
 Enter PARK code (enter nothing if not mandatory).
 Apply.
 Enter access code (enter nothing if not mandatory).
 Apply.
 Select Power mode.
 Legacy Mode:
 Yes / No
Call from encrypted system to un-encrypted system is accepted (yes) or rejected (no).
Launch subscription.
 Return to idle.
 If the registration operation runs correctly (Subscription accepted), the telephone is ready for use, and
the radio coverage icon appears.
 If the registration operation has not been successful, the station proposes launching the subscription
again.
 Depending on the type of system concerned, registration may require one or more additional operations
on the system.