Alcatel-Lucent H2 DeskPhone - Page 82

H2 DeskPhone
H2P DeskPhone
8AL90394ENAAed01 82 /111
immediately if audio channel is opened by off-hook handset or hands-free
speaker or headphone is turned on.
Hotline Delay
Sets the delay for hotline before the system automatically dials it.
Hotline Number
Sets the hotline dialing number.
Dial Without Registered
Sets call out by proxy without registration.
Enable Missed Call Log
If enabled, the phone will save missed calls in the call history record.
DTMF Type
Sets the DTMF type to be used for the line.
DTMF SIP INFO Mode
Sets the SIP INFO mode to send ‘*’ and ‘#’ or ‘10’ and ‘11’.
Enable DND
Enables Do-not-disturb. Any incoming call to this line will be rejected
automatically.
Subscribe For Voice
Message
Enables the device to subscribe to a voice message waiting notification. If
enabled, the device will receive notification from the server if there is a voice
message waiting on the server.
Use VPN
Sets the line to use VPN restricted route.
Use STUN
Sets the line to use STUN for NAT traversal.
Enable Failback
Whether or not to switch to the primary server when it is available.
Failback Interval
A Register message is used to periodically detect the time interval for the
availability of the main Proxy.
Signal Failback
Multiple proxy cases, whether to allow the invite/register request to also
execute failback.
Signal Retry Counts
The number of attempts that the SIP Request considers proxy unavailable
under multiple proxy scenarios.
Codecs Settings
Sets the priority and availability of the codecs by adding or remove them from
the list.
Video Codecs
Selects video code to preview video.
Advanced Settings
Use Feature Code
When this setting is enabled, the features in this section will not be handled
by the device itself but by the server instead. In order to control the enabling
of the features, the device will send feature code to the server by dialing the
number specified in each feature code field.
Enable DND
Set the feature code to dial to the server.
Disable DND
Set the feature code to dial to the server.
Enable Call Forward
Unconditional
Set the feature code to dial to the server.
Disable Call Forward
Unconditional
Sets the feature code to dial to the server.
Enable Call Forward on
Busy
Sets the feature code to dial to the server.