Need help?Do you have a question about the Alcatel-Lucent IP and is the answer not in the manual?
General| Brand | Alcatel-Lucent |
|---|---|
| Model | IP |
| Category | Monitor |
| Language | English |
Specifies environmental conditions for installation like sunlight, heat, condensation, and pollution levels.
Details requirements for power source installation by qualified staff and accessible shutoff devices.
Outlines safe maintenance practices, including unplugging, avoiding liquid cleaners, and not disassembling.
Lists product references, specifically P3540200 for the 2x16 wallboard.
Describes key features such as compatibility, IP and serial connections, display modes, colors, buzzer, and power supply.
Details connection methods including direct, cascade, and Ethernet network for the wallboard.
Outlines the steps for installing the wallboard, including checking supplies, attachment, configuration, and connections.
Lists the required items for wallboard installation, such as the wallboard unit, mounting foot, and cables.
Describes how to physically attach the wallboard using a mounting foot, specifying screw size and ceiling clearance.
Explains how to set the wallboard's operating mode using micro-switches SW1-SW8.
Details how to configure IP settings for the A4400 model using micro-switches and a web browser.
Explains V24 mode configuration for A4400, including wallboard address, baud rate, and buzzer duration settings via switches.
Covers V24 mode configuration for 12-digit ACD CCD A4400, setting address, line display, and text examples.
Details V24 mode configuration for 8-digit A4300, covering address, baud rate, language, and type settings.
Explains how connections are made to the back panel, including Ethernet, V24, and current-loop serial types.
Specifies using a crossed Ethernet cable (FTP or STP) for direct PC connection and EMC compliance.
Details V24 connection pinouts (SG, TD) and the requirement for shielded cables connected to pin 1.
Illustrates cascading multiple wallboards via Ethernet connection, showing the RJ45 interface and maximum distance.
Shows cascading wallboards using V24/Current Loop connection, detailing the wiring and maximum distance.
Outlines the steps for commissioning, including powering on and managing IP settings if applicable.
Describes the wallboard startup sequence, including software version display, IP address, and self-test with color checks.
Explains how to manage IP settings via a PC and web browser for IP mode configurations.
Provides initial steps for commissioning, including removing switches, connecting via Ethernet, and setting PC IP.
Explains how to change operational settings using a PC, web browser, and specific micro-switch (SW5).
Addresses communication failures via Ethernet, suggesting browser proxy settings or parameter resets as solutions.
To Next Page