Alcatel-Lucent OmniPCX Office Installation Manual

Board used for connecting up digital terminals or DECT 4070 IO/EO base stations.
The UAI16-1 board is used to power terminals connected to the 16 interfaces remotely from an
EPS48 external power supply connected to interface 1 via an external adapter cable (splitter).
Caution:
Only use EPS48 power supplies and the splitters provided.
2.4.2.4 MIX x/y/z
These boards are used to connect 2 or 4 base T0 access points, 4 or 8 analog terminals and 4
or 8 digital dedicated terminals.
2.4.2.5 AMIX-1 X/Y/Z Boards
These boards are used to connect 4 analog accesses, 4 or 8 analog terminals and 4 or 8
digital dedicated terminals.
"# !$%  $
          
2-9

Alcatel-Lucent OmniPCX Office Specifications

General

VoIP Protocols	SIP, H.323
Power Supply	100-240 VAC, 50/60 Hz
Humidity	10% to 90% non-condensing
Type	IP PBX
Maximum Trunks	Up to 60
Voice codecs	G.711, G.729
Network Interfaces	10/100 Ethernet
Weight	Varies depending on the model/configuration