Alcatel-Lucent OmniPCX Office

Figure 4.41: 8082 My IC Phone set connectors
4.4.2.1.2 Commissioning the set
This section describes how to commission the set in the two available initialization options:
- Static initialization: commissioning is manual on the set and through OMC
- Dynamic initialization (DHCP): no commissioning is needed, 8082 My IC Phone sets are
fully plug & phone
Depending on the selected mode, the set commissioning is different.
For static initialization, the operation order is as follows:
1. Configure the user in OMC, refer to: Configuring the user in OMC
2. Connect the set, refer to: Connecting the set
3. Configure network parameters on the set, refer to Configuring network parameters for
static initialization
For dynamic initialization, the operation order is as follows:
1. Configure the DHCP Server, refer to Configuring the DHCP server for dynamic initialization
2. Configure the user name and password in OMC, refer to Configuring the user name and
Chapter
4
  ()
4-40
          