Alcatel-Lucent OmniSwitch 6350 - Page 6

Contents
vi OmniSwitch 6350 Hardware Users Guide April 2017
Configuring the Total Power Available to a Port ..............................................5-6
Configuring the Total Power Available to a Switch .........................................5-6
Setting Port Priority Levels ...............................................................................5-7
Understanding Priority Disconnect .................................................................................5-8
Setting Priority Disconnect Status ............................................................................5-8
Disabling Priority Disconnect ...........................................................................5-8
Enabling Priority Disconnect ............................................................................5-8
Priority Disconnect is Enabled; Same Priority Level on All PD .......................5-9
Priority Disconnect is Enabled; Incoming PD Port has Highest Priority Level 5-9
Priority Disconnect is Enabled; Incoming PD Port has Lowest Priority Level 5-9
Priority Disconnect is Disabled .......................................................................5-10
Monitoring Power over Ethernet via CLI .....................................................................5-10
Chapter 7 Managing OmniSwitch 6350 Stacks .....................................................................6-1
In This Chapter ................................................................................................................6-1
OmniSwitch 6350 Stacking Specifications ..............................................................6-2
OmniSwitch 6350 Stack Overview .................................................................................6-2
OmniSwitch 6350 Stacking/Standalone Mode ...............................................................6-3
Roles Within the Stack ....................................................................................................6-3
Primary and Secondary Management Modules .......................................................6-3
Primary Management Module Selection ...........................................................6-6
Secondary Management Module Selection .......................................................6-9
Idle Module Role ....................................................................................................6-11
Pass-Through Mode ...............................................................................................6-12
Recovering from Pass-Through Mode (Duplicate Slot Numbers) ..................6-13
Stack Cabling ................................................................................................................6-16
Redundant Stacking Cable Connection ..................................................................6-17
Checking Redundant Stacking Cable Status ..........................................................6-18
Slot Numbering .............................................................................................................6-19
Dynamic Slot Number Assignment ........................................................................6-20
Manual Slot Number Assignment ..........................................................................6-22
Reverting to the Dynamic Slot Numbering Model ..........................................6-23
Hot-Swapping Modules In a Stack ...............................................................................6-24
Removing Switches from an Existing Stack ..........................................................6-24
Inserting Switches Into an Existing Stack ..............................................................6-24
Merging Stacks .......................................................................................................6-25
Reloading Switches .......................................................................................................6-26
Reloading the Primary Management Module ........................................................6-26
Reloading the Secondary Management Module ....................................................6-28
Reloading Switches with Idle Roles .......................................................................6-30
Reloading Switches in Pass-Through Mode ..........................................................6-30
Reloading All Switches in a Stack .........................................................................6-31
Software Synchronization During a Full Reload .............................................6-31
Effects of Saved Slot Number Information on the Reload Process .................6-31
Avoiding Split Stacks .............................................................................................6-33
Changing the Secondary Module to Primary ................................................................6-34