Alcatel-Lucent OmniSwitch 6350 - Connecting the Chassis to a Power Source; AC Power Supply Connections; Powering on a Chassis

Connecting the Chassis to a Power Source Mounting OmniSwitch 6350 Switches
page 4-8 OmniSwitch 6350 Hardware Users Guide April 2017
Connecting the Chassis to a Power Source
AC Power Supply Connections
Since the power cord is the switch’s only disconnect device, it should be plugged into an easily accessible
outlet. In the event that your power cord is lost or damaged, refer to the specifications below.
Powering On a Chassis
Follow the steps below to power on the chassis using and AC power source:
1 Connect the IEC-60320-C15 end of the supplied power cord to the chassis.
2 Connect power supply to AC power source.
3 Monitor the chassis as it boots.