Alcatel-Lucent OmniSwitch 6450 - LED Status, Expansion Modules, and Power Supplies

OmniSwitch 6450 Chassis and Hardware Components OmniSwitch 6450 LED Status
OmniSwitch 6450 Hardware Users Guide July 2012 page 2-23
OmniSwitch 6450 LED Status
LED State Description
OK Solid Green
Blinking Green
Solid Amber
The switch has passed hardware diagnostic tests and the
system software is operational
Normal diagnostics and/or Remote Config Load in progress
System fan failure or temperature threshold exceeded
PRI Solid Green
Solid Amber
Off
Primary unit in a stack or standalone switch
Secondary unit in a stack
Switch is idle. (not primary or secondary)
PWR Solid Green
Solid Amber
Off
P/S Normal Operation
P/S Present and Bad
P/S Not Present.
STK Solid Green
Solid Amber
Off
Unit in Stacking Mode
Unit in uplink mode
No expansion module present
Stack/Uplink Ports Solid / Blinking Green
Solid / Blinking Amber
Off
Valid Uplink / Activity
Valid Stacking Link / Activity
No Link Detected
10/100/1000 Ports Solid Green
Blinking Green
Solid Amber
Blinking Amber
Off
Valid Link
Transmitting or receiving packets in a link up state for non-
PoE
Valid PoE Link
Transmitting or receiving packets in a link up state for PoE
No Link Detected
SFP Ports Solid Green
Blinking Green
Off
Valid Link
Transmitting or receiving packets in a link up state
No Link Detected