Viewing PoE Power Supply Status Managing Power over Ethernet (PoE)
page 5-4 OmniSwitch 6450 Hardware Users Guide July 2012
Viewing PoE Power Supply Status
To view the current status of power supplies installed, use the show power command, as shown below:
-> show power
Slot PS Wattage Type Status Location
----+----+---------+------+-----------+----------
1 1 900 AC UP Internal
1 2 900 AC UP External
For detailed information on the show power command output, refer to the OmniSwitch 6250/6450 CLI
Reference Guide.
Configuring Power over Ethernet Parameters
Power over Ethernet Defaults
The following table lists the defaults for PoE configuration:
Understanding and Modifying the Default Settings
The sections below provide information on each of the key components within the Power over Ethernet
software. They include information on PoE-related CLI commands. For detailed information on PoE-
related commands, refer to the OmniSwitch CLI Reference Guide.
Note. PoE units support different wattage power supplies. If an unsupported power supply is used, a
console message and a trap are generated.
Parameter Description Command(s) Default Value/Comments
PoE operational status lanpower start or lanpower stop Disabled
Total power available to a port lanpower power 31 Watts (802.3at)
Total PoE power available to an
entire chassis
lanpower maxpower Varies depending on chassis and
power supply type. Refer to the
OmniSwitch 6250/6450 CLI Ref-
erence Guide.
Power priority level for a port lanpower priority Low
Priority disconnect status lanpower priority-disconnect Enabled
To Next Page
Loading...
