Mounting OmniSwitch 6450 Switches Rack-Mounting 24 and 48-Port OS6450 Switches
OmniSwitch 6450 Hardware Users Guide July 2012 page 3-11
Rack Mounting Steps
1 Mark the holes on the rack where the switch is to be installed.
2 Lift and position the switch until the rack-mount flanges are flush with the rack post.
3 Align the holes in the flanges with the rack holes that were marked in step 3.
4 Once the holes are aligned, insert a rack mount screw (not provided) through the bottom hole of each
flange. Tighten both screws until they are secure.
Note. Be sure to install the screws in the bottom hole of each flange, as shown, before proceeding.
5 Once the screws at the bottom of each flange are secure, install the remaining two rack mount screws.
Be sure that all screws are securely tightened.
To Next Page
Loading...
