Managing Power over Ethernet (PoE) Power over Ethernet Specifications
OmniSwitch 6450 Hardware Users Guide July 2012 page 5-3
Power over Ethernet Specifications
The table below lists general specifications for Alcatel-Lucent’s Power over Ethernet support. For more
detailed power supply and Power Source Equipment (PSE) specifications, refer to Chapter 2,
“OmniSwitch 6450 Chassis and Hardware Components.”
IEEE Standards supported
IEEE 802.3at
Default PoE administrative status Enabled
Default PoE operational status Disabled (PoE must be activated on a switch-
by-switch basis via the lanpower start com-
mand.)
Platforms supporting PoE OmniSwitch 6450-P10, OmniSwitch 6450-P24,
OmniSwitch 6450-P48
Cable distances supported 100 meters (approx.)
PoE-capable ports per switch 10 (OmniSwitch 6450-P10)
24 (OmniSwitch 6450-P24)
48 (OmniSwitch 6450-P48)
Default amount of inline power available 31000 milliwatts
Range of inline power allowed 3000 - 31000 milliwatts
PoE Power Available OmniSwitch 6450-P10 - ~ 90W
OmniSwitch 6450-P24 - ~ 390W
OmniSwitch 6450-P48 - ~ 740W
To Next Page
Loading...
