Alcatel-Lucent OmniSwitch 6450 - Page 87

Managing OmniSwitch 6450 Stacks Roles Within the Stack
OmniSwitch 6450 Hardware Users Guide July 2012 page 6-5
Note. For management module redundancy to work effectively, the software on all switches operating in
the stack must be synchronized at all times. Refer to “Synchronizing Switches in a Stack” on page 6-37
for more information.
Redundant Management Module Failover (Three or More Switches)
Secondary
Primary
Idle
Idle
Secondary
Offline
Idle
Idle
Primary
Offline
Secondary
Idle
!
Primary
Idle
Secondary
Idle
A stack of four OmniSwitch 6450 switches is
operating normally. The stack consists of a pri-
mary module, secondary module, and two ele-
ments operating in idle status. (The software
The primary management module in the stack
fails or is taken offline (e.g., powered off or
The switch operating as the secondary manage-
ment module immediately takes over the primary
role. Meanwhile, the adjacent switch—previously
If the switch that failed or was taken offline comes
back online, it will assume an idle role in the
stack. In other words, it will act essentially as an
1
2
3
4