Mounting OS6855-14 and OS6855-U10 Switches Wall-Mounting OS6855-14 and OS6855-U10 Switches
OmniSwitch 6855 Series Hardware Users Guide March 2009 page 4-21
Installation
1 To wall mount the switch, follow steps 1 through 7 in the “Table-Mounting OS6855-14 and OS6855-
U10 Switches” section above.
2 Use one person to securely hold the chassis assembly in position on the wall. Mark the location of the
holes in the mounting brackets on the wall.
3 Pre-drill the wall (if required).
Recommended Wall Mount Chassis Orientation
Note. Wall fasteners are not provided with your switch and will vary depending on the type of wall
surface. Be sure to use fasteners that are approved for the full weight of the chassis assembly. Consult
fastener specifications for full details.
4 Secure the unit to the wall using appropriate wall fasteners.
NOTE: For wall mounting, it is recommended that the
chassis assembly is oriented sideways, with the chassis
front panel facing left, as shown in the diagram below.
Power supply
Wall surface
Chassis assembly
To Next Page
Loading...
