Console Port OmniSwitch 6855 Series Chassis and Hardware Components
page 2-40 OmniSwitch 6855 Series Hardware Users Guide March 2009
Console Port
The console port, located on the chassis front panel, provides a console connection to the switch and is
required when logging into the switch for the first time. By default, this RJ-45 connector provides a DTE
console connection.
Serial Connection Default Settings
The factory default settings for the serial connection are as follows:
baud rate 9600
parity none
data bits (word size) 8
stop bits 1
flow control none
To Next Page
Loading...
