Alcatel-Lucent OmniSwitch 6855-24 - Status Leds

Status LEDs OmniSwitch 6855 Series Chassis and Hardware Components
page 2-16 OmniSwitch 6855 Series Hardware Users Guide March 2009
Status LEDs
LEDs provide visual status information. These “status lights” are used to indicate conditions, such as
hardware and software status, primary role status, power supply status, fan and temperature errors, data
speed, link integrity, and activity. Refer to the diagram below for detailed information on LED states.
Displays solid green when an SFP is installed in
the corresponding port and a link state exists;
blinks green when transmitting or receiving traf-
fic; off when no activity is present or no SFP is
installed.
By default, when an SFP is installed, it takes over
the port number of the corresponding RJ-45 Ether-
net port. If an SFP is installed in the slot labeled
23, Ethernet port 23 is no longer available and
cannot be used for 10/100/1000 traffic. For
detailed information on changing combo port set-
tings, see “Configuring Ethernet” in the Network
Combo Port Status LEDs
OK. Solid green when the switch has
passed hardware diagnostic tests and
the system software is operational.
Solid amber when a hardware or sys-
tem software failure occurs. Blinks
green during normal diagnostics.
PS1. Solid green when the pri-
mary (i.e., factory-installed)
power supply status is OK and
the power supply is operating
normally. Solid amber in the
event of a power supply fail-
ure.
PS2. Solid green when an
System Status
OmniSwitch 6855-24
OK
PS1
PS2
Console
USB
CLASS 1 LASER PRODUCT
21 22 23 24
1 5 9
2 6
10
3 7
11
4 8
12
13 17 21
14 18
22
15 19
23
16 20
24
21
22
23
24
PoE
1 3 5 7 9 11
2 4 6 8 10 12
13 15 17 19 21 23
14 16 18 20 22 24
Ethernet Port LEDs
10/100/1000 Ethernet port have one
built-in status LED. This LED indicate
the data speed and link/activity either
PoE or non-PoE status for each corre-
sponding Ethernet port. 1000 Mbps SFP
have a single LED for activity. See page
2-16
for more information.