Mounting OS6855-24 and OS6855-U24 Installing Power Supplies
OmniSwitch 6855 Series Hardware Users Guide March 2009 page 3-9
Securing Power Supply Cord
The following section describes how to secure the power supply cord to the power supply using the
included power supply cord retaining bracket.
1 If necessary, disconnect the AC power cord from the power supply.
2 Remove the screw directly above the AC power supply receptable on the power supply and set aside,
this screw will be used to secure the power supply cord retaining bracket.
3 Plug the AC power cord into the AC power supply receptacle on the power supply.
4 Slide the power cord retaining bracket’s slot over the AC power cord.
5 Slide the bracket towards the chassis until the top hole in the bracket lines up with the screw hole in the
power supply.
6 Secure the power cord retaining bracket to the power supply using the power supply screw removed in
step 2 above.
Power Cord Retaining Bracket
Use top hole to secure
the power supply cord
retaining bracket.
To Next Page
Loading...
