Rack-Mounting OS6855-14 and OS6855-U10 Switches Mounting OS6855-14 and OS6855-U10 Switches
page 4-6 OmniSwitch 6855 Series Hardware Users Guide March 2009
2 Attach the S-bracket that was removed at step 1 to the right-rear portion of the power supply tray, as
shown. Use the single power supply tray attachment screw (provided).
3 Next, plug the connector cable from your power supply into the PS1 port located in the back of the
switch chassis, as shown.
4 If no additional power supplies are required, skip to step 5. Otherwise, refer to the additional
information on the following configurations: redundant chassis power, PoE, and redundant chassis power
with PoE.
Redundant Chassis Power
For OS6855-14 or OS6855-U10 switches using redundant chassis power, a second power supply is
required.
For this configuration, plug the connector cable from the second power supply into the PS2 port on the
rear panel of the chassis.
When complete, continue to step 5.
Re-attach the S-bracket removed at step one
to the power supply tray, as shown.
S-bracket
Power supply tray
Connector cable
Rear of chassis
PS1 port
To Next Page
Loading...
