7.24. Installing a Bluetooth® Wireless Technology handset (matching)
Before a Bluetooth® headset can be used, it must be correctly matched to the terminal.
Reach the "Menu" page
Settings Phone Bluetooth Add device
With the handset turned off, press the 2 Bluetooth® handset keys at the same time (long
press)
You will hear a 3 note signal and the LED will flash green and orange alternately
Searching for Bluetooth® equipment. Wait for the detected equipment type and address to be
displayed
Select the relevant equipment
Add The 3-note tone indicates that the handset has been installed correctly (the LED flashes
green or orange depending on the battery charge level)
Error messages
The Bluetooth® handset emits a sequence
of 4 beeps
Your set is an older generation than your
Bluetooth® handset
The set displays an error message
indicating that the set and the Bluetooth®
handset are incompatible
Your Bluetooth® handset is an older
generation than your set
7.25. Use of the Bluetooth® handset
The Bluetooth® cordless handset permits the user to answer and converse with complete freedom
within a radius of 10 meter from the set.
The handset has a LED and two buttons.
Light
Green flashing: normal operation.
Green steady: handset charging.
Orange flashing: battery charge low or handset outside coverage zone.
Orange steady: malfunction.
Off-hook/On-hook and Volume/Mute keys
Off-hook/On-hook: press this key to take or terminate a call.
Volume/Mute:
o Short successive presses to change the handset volume level (3 levels)
o Long press to ensure your correspondent no longer hears you
If the Bluetooth® handset is on its base, you do not need to press the Off-hook/On-hook key to take or
terminate the call. Just off-hook/on-hook the Bluetooth® handset
To Next Page
Loading...
