Alcatel 4035 - Operation of Keys SK1 to SK5; Function Key SK1; Function Key SK2

Presentation of the attendant set
3BA 19875 ENAA - Ed. 02 - April 2000 - Alcatel 4035 - Attendant set 1-7
1-5-3 Operation of keys SK1 to SK5
1-5-3-1 Function key SK1
• With the label «Reseiz» displayed
This label is displayed during an o/g call to the exterior, on transmission of the first digit of the
external number.
This function is used to renew the numbering on the same line: the system automatically carries
out release and line seize and, on display of the trunk number, it is possible to start numbering
again.
• With the label «EnqOff» displayed
This function is used to release the enquiry call communication and return to conversation mode
with the first correspondent.
1-5-3-2 Function key SK2
• With the label «Ring» displayed
Following an ordinary call or an enquiry call to an internal user, this function is used to activate
ringing on the set on which the call has been connected.
If the set is free, its number is shown on the display preceded by the indication «Free».
If this user has just off-hooked before the call, it receives the music on hold indicating that it is
«reserved» by the attendant and «Conv» is displayed before the number: in this position,
pressing this key can then be used to enter into conversation with the internal user.
• With the label «Broker» displayed
This function is used, when the conversation in enquiry call mode has been established, to change
from one correspondent to the other by pressing the key, with automatic hold of the other
correspondent.
• With the label «Intrud» displayed
Following an ordinary call or enquiry call to an internal user, this function can be used - if the
link is not protection against intrusion - to intrude on the communication of the set on which the
call has been connected. The number of this set is shown on the display, preceded by «Busy.I»
or «Busy.E».
The intrusion is accompanied by a specific tone sent to all participants.
• With the label «IntOff» displayed
If the intrusion is accepted, the display changes and the «cancel intrusion» becomes active.