Alcatel 4035 - Key facilities programmable by system management; Directory number supervision; Individual routing

3BA 19875 ENAA - Ed. 02 - April 2000 - Alcatel 4035 - Attendant set 4-1
Chapter
4 Key facilities programmable by
system management
▼ Directory number supervision
By this programming, pressing the key activates ringing directly on the user set. The pictogram
is off if the user set is idle position and free.
The pictogram :
- « » indicates that the user is busy,
- « » indicates that the user is in call mode to the attendant set,
- « » indicates that the user is on hold. It flashes when the timer has expired,
- « » indicates that the user has left a call-back request.
A set can be supervised by one or more attendants.
▼ Abbreviated number
An often used abbreviated number to the exterior can be programmed directly on a key. Pressing
the key activates the o/g call as if it had been dialled on the keypad.
▼ Individual routing
This function allows the attendant to route and supervise an external «incoming» call without this
call being placed in the common waiting queue and re distributed.
When a call is being routed, the «
» pictogram is lit. If the set does not reply before the
end of the routing timer, the «
» pictogram will flash to indicate the change to «urgent»
wait (individual routing does not increment the «Normal wait - Urgent wait» counters).
As long as the set has not answered, the attendant can retrieve the call by pressing the routing
key ; the flashing «
» pictogram goes out.
Note: In the case of a local call or o/g call, this key can be activated. It is used to transfer the call.
▼ Network / network transfer
This function is used to inter-connect 2 external trunks via the installation, with the possibility of
releasing the connection.
After an incoming call, the attendant initiates an outgoing call to a correspondent and enters
conversation.