Alcatel 4035 - I;C External Communication; O;G External Communication; Dialling Keypad; Loudspeaker and Hands Free

Chapter 1 Presentation of the attendant set
1-12 3BA 19875 ENAA - Ed. 02 - April 2000 - Alcatel 4035 - Attendant set
1-7-3-3 I/c external communication
After call answer, and whenever the attendant is in communication with the trunk, the screen will
display the following information (from left to right):
a. Trunk status
•Conv
The trunk is considered by the PBX as being in conversation.
• Free
The external correspondent has on-hooked and the PBX has received a release signal.
b. The name of the trunk group to which the trunk belongs.
c. The number of the trunk.
1-7-3-4 O/g external communication
As soon as the seize prefix is dialled, the name of the trunk group is displayed (in case of overflow,
the name displayed is that of the trunk group actually used).
If no trunk is available, the label «Trunk unobtainable» is displayed.
The external number is displayed as the digits are dialled.
On entering conversation (reception of the answer signal or reception of the first charging unit
after the timer), the attendant is in the case of an i/c call
(see § 1-7-3-3) .
1-8 Dialling keypad
The dialling keypad has 12 keys: 1 to 0, *, #.
1-9 Loudspeaker and «Hands free»
The loudspeaker is located under the handset and the «Hands free» microphone is located
above at the bottom right of the set.
These 2 functions are automatically cut-over when the attendant set is used in «Hands free»
position. On the other hand, the loudspeaker can be validated when the attendant set is used
from the handset.
In both operating cases, the loudspeaker volume can be adjusted. Validating the «Hands free»
position and loudspeaker volume level are activated using the « » (Hands free), « »
(Loudspeaker), « » and « » fixed keys.
OK
+
_