Alcatel 4035 - By Abbreviated Dialling; By Programmed Key; Routing with Presentation; Routing an External O;G Call to a Free Set

Chapter 2 Attendant set facilities
2-28 3BA 19875 ENAA - Ed. 02 - April 2000 - Alcatel 4035 - Attendant set
2-1-5-2 Routing with presentation
By pressing the «Ring» key, the attendant puts the correspondent on hold and calls on the called
party side.
The following is displayed:
The attendant remains in call mode and waits for the internal called party to answer.
When the user off-hooks, the attendant presents the communication.
By pressing the «Transf» key, the attendant exits the conversation and the attendant set returns
to idle position. The internal user is put into conversation mode with the correspondent.
By pressing the «Releas» key, the attendant releases the conversations (B.T.) and the attendant
set returns to idle position.
2-1-6 Routing an external o/g call to a free set
2-1-6-1 The set is not in connection with the attendant set
The attendant enters conversation mode with an external correspondent by:
- prefix or access code,
- abbreviated dialling,
- programmed key.
(See the description of the procedure in § 2-1-3).
From this state, the attendant can:
- route the correspondent without presentation,
- route the correspondent with presentation.
The signalling during these routings is the same as for i/c routings.
Note: The charge units are charged to the attendant set when it is the last to be involved in a communication
(in case of no answer to a transfer, for example).
2-1-6-2 The set remains in connection with the attendant set
In this case, the attendant enters conversation mode with the external correspondent during the
enquiry call phase. The link is established by an ordinary transfer.
Broker
CallBk
(cat)
Ring
Releas
Repertory
user
Transf
EnqOff