Alcatel XP1050 - Page 51

51
Notes:
• Once the new messages have played, the telephone announces the help
menu options. If you do not press any key within 20 seconds, the remote
access call automatically disconnects.
• When your answering machine is turned off, the telephone answers after 10
rings, and announces, “Please enter your remote access code.”
• When the memory is full, your answering machine answers incoming calls
after 10 rings and announces, “Memory is full. Enter the remote access
code.”
10.6.5. Message Alert Tone
When the message alert tone is set to On, the telephone base beeps every 10
seconds to alert you to new messages. The tone stops when all new messages
have been reviewed.
1. Press MENU on the handset in idle mode.
2. Use
or to select Answering sys, then press SELECT.
3. Use
or to select Ans sys setup, then press SELECT.
4. Press
or to select Msg alert tone, then press SELECT.
5. Press
or to select between On and Off, then press SET to save your
setting. You hear a confirmation tone.
Temporarily turning off the message alert tone
Pressing any telephone base key (except
) temporarily silences the message
alert tone.
The message alert tone plays with the next incoming message.
If you press
when in idle mode to temporarily turn off the message alert
tone, there is a voice prompt directing you to press
again to delete all old
messages. The message alert tone is temporarily off. Only press
a second
time if you wish to erase all old messages in your answering machine.
The message alert tone resumes when you receive a new message.