40
5.4 Installing a wall ue
•
past it.
• Lateral distance to the projecting part must be min. 200 mm, see Fig. 6.
•
•
•
regulatory requirement). Always comply with national provisions in force.
Procedure:
•
•
is marked TOP/OPEN.
• If the surface of the vehicle is textured, e.g. shot peened panels, use a sealant for bodywork around
the gasket.
• Fit the plastic cap (Fig. 7, item 3) and O-ring (Fig. 7, item 4) using the two screws supplied.
Fig. 7, Installing a wall ue
1
2
3
4
5
6
7
8
9
Fig. 5, Placement, wall ue
200 mm
Windows
Prohibited zone
Fig. 6, Distance to wall ue
To Next Page
Loading...
