52
11. Starting the heating system for the rst time
1. Start the heating system by pressing the ON/OFF button on the control panel. (Fig.25 item 1)
When the heating system and control panel are on, a green diode is lit on the ON/OFF button.
2.
3.
pressing the
option arrives.
5. Dual zone system
respective menus. (Fig. 30)
• Go back using the Back arrow in the left corner, and select “Done”.
- Switching a pump to continuous operation may entail impaired hot water operation.
The relevant function is highlighted if connected:
Pump, 12 V pump, Single zone DuoControl, Bottle Switch
Booster fan EisEx (Defroster)
Remote Control
Engine pre-heat, engine heater. Heat the
engine using the Alde heating system.
2 zone mode
Extra hot water tank/Alde Flow, for
increased hot water capacity and
continuous hot water. (Not 3030 Plus)
Alde AquaClear
Fig. 24
1
Fig. 25. 1 ZONE
Fig. 26. 1 ZONE
To Next Page
Loading...
Need help?
General
