EasyManuals Logo

Alde Compact 3030 Installation Instructions

Alde Compact 3030
Go to English
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
48
7. Pump installation
12 V potentiometer pump: 
the normal position is 2, which is suitable in most instances. Install it on the boiler or in the system;
see Figs. 11-14, pp 42-43.
PWM-controlled 12 V pump: 
normal setting is 2, which is suitable in most instances. Install on the boiler.
7.1 Pump installation 3030:
3030,Single-zone system
Choose between a 12 V potentiometer pump or a PWM -controlled 12 V pump.
1. 
3030, double zone system
Two x 12 V potentiometer pumps are used to circulate the glycol in the system.

1. 
behind the service hatch and control zone 1.
2. A 12 V potentiometer pump is always connected to the optional connector on the circuit board
and control zone 2.
7.2 Installing pumps 3030 Plus:
3030 Plus, single zone system
1. 
3030 Plus, dual zone system
In dual zones, there is a choice of using 2 or 3 pumps:
Solution with dual pumps:
1. A PWM-controlled 12 V pump and control zone 1 are factory installed.
2. A 12 V potentiometer pump is always connected to the optional connector on the circuit board
and control zone 2.
Solution with 3 pumps:
1. Connect a 12 V potentiometer pump and 3-way valve to the Alde Flow input on the option board
via a splitter, (part number 3030206), and must always be set to maximum (5). This is factory-in-
stalled on the boiler.
2. Dual pumps must then be connected for the 2 zones. There are dual-pump kits available for order
from Alde, e.g. part numbers 1900984, 1900981 and 1900982.
Connect the pumps as follows:
A. A 12 V potentiometer pump controls zone 1 and must be connected to the Pump zone 1 con-
nector, (Fig. 20, page 49).
B. Connect a 12 V potentiometer pump to the optional connector on the circuit board; it controls
Pump zone 2, (Fig. 20, page 49).

Other manuals for Alde Compact 3030

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alde Compact 3030 and is the answer not in the manual?

Alde Compact 3030 Specifications

General IconGeneral
BrandAlde
ModelCompact 3030
CategoryWater System
LanguageEnglish