APPENDIX
B
ALF Instruction Manual UM_Filter_100B03
Page 61 of 67
12.1.13.3 Settings -> 8 IP Settings -> 3 Change subnet mask
Figure 62
12.1.14 Password/Login
On entering 8 Password/Login the following menu is displayed:
__ Password handling __
1 Login
2 Logout
3 Change user PW
4 Change service PW
Figure 63
On delivery, user password is 0000 (= no password), and service password = AL password. The
user password corresponds to protection level 1, and the service password corresponds to
protection level 2. Protection level 0 means that no password is required.
Access to resp. protection level is given when the operator enters the right password using
procedure 1 Login. The password is then valid for 20 minutes, or until procedure 2 Logout is used.
The current AL password is 1361. Could also be 1362, 1363, 1364, 1365, if necessary to be
changed.
The operator can set an own password using procedure 3. This password can be removed by
changing back to 0000 if logged in.
The service password overrides the user password and cannot be changed or removed.
12.1.14.1 Settings -> 9 Password/LogIn -> 1 Login
Figure 64
12.1.14.2 Settings -> 9 Password/LogIn -> 2 Logout
Figure 65
C u r r e n t s u b n e t m a s k :
2 5 5 . 2 5 5 . 0 . 0
N e w s u b n e t m a s k
- - - - - - - - - - - - - - - - - - -
_ _ _ P A S S W O R D _ _ _ _ _ _ _ _
E n t e r p a s s w o r d
* * - -
_ _ _ P A S S W O R D _ _ _ _ _ _ _ _
L o g g e d o u t
_ _ P a s s w o r d h a n d l i n g _ _ _
1 L o g i n
2 L o g o u t
3 C h a n g e u s e r p w
_ _ P a s s w o r d h a n d l i n g _ _ _
4 C h a n g e s e r v i c e p w