43
5 Installation and first start 5.1 Before first start
5.2 Before first start
• Pour about 13 litres lubricating oil of correct
grade into the worm gear housing – see
“Lubricants” in
Installation Manual
.
• Check the oil (approx. half way up the sight
glass). Be aware of that a very small quantity
of oil may remain at the bottom edge of the
sight glass even when the gear housing is
emptied for oil.
• Assemble the bowl and the inlet and outlet
parts as described in the
Service &
Maintenance Manual
.
• Make sure that the frame hood bolts have
been tightened.
• Make sure that the bolts for centring ring and
outlets have been tightened to the correct
torque. See Service &
Maintenance Manual
.
• Make sure that the bolts for the inlet device
have been tightened.
• Check that water and air are being supplied
to the control panel.
Make sure that cooling water is being supplied to
the separator.
Check at
(1) – from inlet device seal
(2) – from outlet upper seals (twin phase
separators only, see ill.)
(3) – from outlet bottom seal (at operation).
S0117811S0117911S0118021S0118111G0699221
To Next Page
Loading...
Need help?
General
