53
7 Operating routine 7.1 Check points
6. Check that water flows from the oil cooling
coil and the axial seals.
7. Choose production mode when the separator
is ready for production.
7.1.3 Separation
• Check that the machine has correct inlet and
outlet pressures.
• Check the throughput.
• Make sure that air is not sucked into the feed
line.
7.1.4 Cleaning
Cleaning of machine after separation is
imperative.
8. When rinsing with water, set the programme
selector to “CIP WATER”. Discharges will
now follow at preset intervals.
When washing with detergent, set the
programme selector to “CIP LYE / ACID”.
Discharges will now take place at preset
intervals.
Check that detergent is flowing from the axial
seals.
To effect a manual ejection, press the button
for ejection (sediment discharge).
DANGER
Abnormal vibration of the
machine during run-up may be
due to wrong assembly or bad
cleaning of the bowl.
If so, stop the machine
immediately and inspect the
bowl.
S0120911S0055611S0121011S0121011
To Next Page
Loading...
Need help?
General
