8138 SIP Multicolor Strobe Light
Password
Password to log into the 8138 SIP Strobe Light web interface. You should change the
default password algo in order to secure the device on the network. If you have forgotten
your password, you will need to perform a reset using the Reset Button in order to restore
the password (as well as all other settings) back to the original factory default conditions.
For additional password security see “Force Strong Password” below.
Confirmation
Re-enter network admin password.
Device Name (Hostname)
Name to identify the device in the Algo Network Device Locator Tool.
Introduction Section on Status Page
Allows the introduction text to be hidden from the login screen.
Show Status Section on Status Page when Logged Out
Use this option if you wish to block access to the status page when logged out. The
settings and configurations, on the status page, will be hidden entirely unless you’re
logged in – this feature is useful when you want only trusted users to view possible
sensitive device information.
Display Switch Port ID on Status Page
Switch port ID can be displayed on the status page, however the switch must support
LLDP or CDP.
Web Interface Session Timeout
Set the maximum period of inactivity after which the web interface will log out
automatically.
Log Level
Use on the advice of Algo technical support only.
Log Method
Allows the 8138 to write to external Syslog server if the option for external (or both) is
selected.
Log Server
If external (or both) is selected this is the address of the Syslog server on the network.
Web Interface Protocol
HTTPS is always enabled on the device. Use this setting to disable HTTP. When HTTP is
disabled, requests will be automatically redirected to HTTPS. Also note that since the
Document 90-00102C
11/27/2019
Page 36
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
