ALIBI ALI-NS8014VR - Page 3

iiiALI-NS8014VR IP PTZ Camera Installation and Setup Guide
SAFETY INSTRUCTIONS
Regulatory information
FCC information
FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his
own expense.
FCC conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Preventive and Cautionary Tips
Before connecting and operating your cameras, please be advised of the following:
• Ensure environmental conditions meet factory specications.
• Major shocks or jolts to the unit as a result of dropping it may cause damage to the sensitive electronics within the unit.
• Use the device in conjunction with an UPS if possible.
Safety Instructions
These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss.
The precaution measure is divided into Warnings and Cautions:
• Warnings: Neglecting any of the warnings may cause serious injury or death.
• Cautions: Neglecting any of the cautions may cause injury or equipment damage.
Warnings
• Always use a power adapter which meets the safety extra low voltage (SELV) standard. The power consumption cannot be
less than the required value. See the Specications section.
• This installation should be made by a qualied service person and should conform to all the local codes.
• Please install blackouts equipment into the power supply circuit for convenient supply interruption.
• If the product does not work properly, contact your dealer or Alibi Support center. Never attempt to disassemble the product
yourself. We will not assume any responsibility for problems caused by unauthorized repair or maintenance.